This depends on the environment. If VuPlex® is used indoors, the effect will last much longer. The average outdoor effect is about three months. If the gloss starts to decrease, you can simply reapply VuPlex®.

375 grs canister = 30 m2

200 grs canister = 16 m2

50 grs canister = 5 m2

Yes, but only in very small quantity and it does not adhere to the surface

Yes, but it is not recommended due to decreasing wiper performance

VuPlex® is ontworpen voor het reingigen en onderhouden van plastic/kunststof, zoals bijv. de voorruit en helmvizier. Het kan echter ook op andere harde en zachte onderdelen van de motor/scooter worden gebruikt (bijv. chroom, vinyl, etc.)

Yes, the formula is specially designed to remove such materials. VuPlex® removes insects, rubber, tar, sticker glue, etc. and also makes new dirt less likely to adhere.

No, this is not recommended as the surface becomes very slippery.

No, VuPlex® cannot prevent condensation.

Yes, VuPlex® prevents water from adhering to windscreen or helmet visor. It is specially designed for this purpose

No, the microfilm has a very high temperature tolerance.

Note: Apply VuPlex® when the exhaust is cold.

No, VuPlex® is not certified as such. It is up to individual manufacturers to recommend its use. There are no regulations on the use of cleaners on acrylic windows. Our best advertisement is the fact that VuPlex® is used in Australia by Qantas on Bombardier Dash-8 aircraft.

This mil-spec is the US designation for the care and maintenance of aircraft acrylic windows and is followed as a standard in some parts of the world. VuPlex® meets and even exceeds this specification, even though it does not have an actual military specification.

No, it is actually designed to slow down this process. Hairline cracks are caused by moisture penetrating the surface. When the aircraft is at a high altitude, the temperature drops below freezing. This causes the moisture to expand and cause small cracks. VuPlex® is designed to seal the pores of the plastic, preventing moisture from penetrating the plastic and preventing cracks. In addition, VuPlex® has a water-repellent effect.

Hairline cracks can also be caused by using the wrong chemicals when cleaning the surface.

No, if proper preparations are made, VuPlex® will not affect this.

Yes, this is possible if the gel coating is in reasonable condition, i.e. not too far weathered.

Yes, VuPlex® seals the surface of plastic and is water-repellent. When the water dries up, the remaining salt crystals do not adhere to the surface. They are easily removed with clean water.

Acrylic (perspex, plexiglass) is very sensitive to scratches. Especially in water sports, sand and dried salt crystals will quickly abrade the surface if not cleaned properly. Moreover, salt can settle in the pores and scratch. When the salt dries in, it causes reduced brightness together with the micro-scratches.

Clear (new) PVC/acrylic is originally porous and, over time, dirt and salt accumulate and this leads to unsafe and clouded vision.

VuPlex® works on boats in four ways:

1. It removes salt and other contaminants from pores and scratches using safe, chemical substances that cannot damage the plastic/plastic.
2. It has an anti-static effect
3. It applies a polymer film that repels water and salt
4. It increases scratch resistance

Yes, VuPlex® is ideally suited for this purpose. It ensures that screens do not scratch and information remains optimally visible.

Yes, this is another one of the great uses of the product

Yes, VuPlex® also cleans this material

No, unfortunately! This ink is very difficult to remove.

No, VuPlex® is not suitable for this application